Latest Posts

1. Build Pics/Information Thread
   [QUOTE] If you are using TIG, you can expect about 10-15% of the weld gap width shrinkage.  I usually overclock the barrel stub the amount I...
   2019-02-18 21:19:45 -06:00, Bryan
2. Build Pics/Information Thread
   [QUOTE] I intend to do two builds. I'll use a complete receiver for the first and a reweld for the second. I'm just concerned about shrinkage...
   2019-02-18 20:54:05 -06:00, Aaron Kroll
3. Build Pics/Information Thread
   Couple of questions on your project. Are you planning on using the complete rec for your build? If so all you will have to worry about is...
   2019-02-18 20:18:04 -06:00, MotoG5
4. Build Pics/Information Thread
   [QUOTE] I've got a similar setup in that I'll be using pieces from two different kits together and having only two welds. I plan to pick up a...
   2019-02-18 19:05:36 -06:00, Aaron Kroll
5. Build Pics/Information Thread
   [QUOTE] I picked up one of the Cajun Country DPM jigs. The jig is not really as good as I had hoped and lets just say if I had it to do over I...
   2019-02-18 17:27:52 -06:00, MotoG5
6. Build Pics/Information Thread
   What are you using for a jig to reweld?
   2019-02-18 13:15:09 -06:00, Aaron Kroll
7. Build Pics/Information Thread
   Looking good so far!
   2019-02-12 10:11:34 -06:00, Bryan
8. Build Pics/Information Thread
   Thought it would be helpful to start a thread where build pics and information exchange could go. The pics below are of my current DPM project....
   2019-02-11 17:47:49 -06:00, MotoG5
9. DP Receivers
   [QUOTE] They're getting their final machine work after heat treat done now.  About 2 weeks...
   2019-02-10 13:00:20 -06:00, Bryan
10. DP Receivers
    I think this will be a useful format for keeping up with you guys. I'll give it a whirl.... When do you guys expect to do another run of DP...
    2019-02-10 11:07:54 -06:00, Aaron Kroll